Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › 2020.03–2020.07
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0425342 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the skid control ECU (brake booster with master cylinder assembly).

The skid control ECU (brake booster with master cylinder assembly) records DTCs when it detects a malfunction in itself or in its circuits.

To check for DTCs, connect the GTS to the DLC3 on the vehicle. The GTS can be used to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.

a.

Check the auxiliary battery voltage.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge the auxiliary battery before proceeding to the next step.




DIAGNOSIS


a.

If the skid control ECU (brake booster with master cylinder assembly) detects a malfunction, the ABS warning, brake system warning (red indicator), brake system warning (yellow indicator) and slip indicator lights will come on in order to warn the driver.


b.

DTCs are simultaneously stored in memory.

The DTCs can be read by connecting the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>DTC CHECK / CLEAR




DTC FOR RELATED SYSTEM MALFUNCTION


a.

When the skid control ECU (brake booster with master cylinder assembly) detects DTCs stored by related systems, it stores DTCs to indicate the malfunctioning system.

DTC for Related System Malfunction
Malfunctioning System Output DTC DTC Storage System/Control Condition
Hybrid control system DTC U029387
DTC U115087
Current and history DTCs are cleared when the system returns to normal. VSC system is disabled
Airbag system DTC U015187 Current DTCs are cleared when the system returns to normal. Secondary collision brake control operation is prohibited

HINT:

The above DTCs may be stored in the skid control ECU (brake booster with master cylinder assembly) even if it was never stored as a history DTC or cleared in the system that caused the DTC to be stored.




WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK


a.

When the ignition switch is turned to ON, check that the ABS warning, brake system warning (red indicator), brake system warning (yellow indicator), VSC OFF indicator and slip indicator lights all come on for approximately 3 seconds.

HINT:
·

When the brake fluid level is low, the brake system warning light (red indicator) comes on.

·

If the warning light and indicator light check results are not normal, proceed to troubleshooting for the ABS warning, brake system warning (red indicator), brake system warning (yellow indicator), VSC OFF indicator, slip indicator light circuits.

·

If an indicator remains on or does not come on, proceed to troubleshooting for the light circuits listed below.



Trouble Area See Procedure
ABS warning light circuit (Remains on) (Click here)
ABS warning light circuit (Does not come on) (Click here)
Brake system warning light (red indicator) circuit (Remains on) (Click here)
Brake system warning light (red indicator) circuit (Does not come on) (Click here)
Brake system warning light (yellow indicator) circuit (Remains on) (Click here)
Brake system warning light (yellow indicator) circuit (Does not come on) (Click here)
VSC OFF indicator light circuit (Remains on) (Click here)
VSC OFF indicator light circuit (Does not come on) (Click here)
Slip indicator light circuit (Remains on) (Click here)
Slip indicator light circuit (Does not come on) (Click here)