Home › Engine / Hybrid System › M15A-FXE (EMISSION CONTROL) › EGR VALVE › 2020.03–2020.07
RM36W0E _51 Engine / Hybrid System _088663 M15A-FXE EMISSION CONTROL _0427223 EGR VALVE A

M15A-FXE EMISSION CONTROL  EGR VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Replacement of EGR valve assembly

·

Gas leaks from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide G9200 3.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 4.REMOVE EGR VALVE WITH EGR COOLER ASSEMBLY

a.
A465940

Slide the clip and remove the No. 5 water by-pass hose from the EGR valve assembly.


b.
A465941

Slide the clip and remove the No. 3 water by-pass hose from the EGR valve assembly.


c.
A465942

Slide the clip and remove the No. 4 water by-pass hose from the EGR valve assembly.


d.

Disconnect the wire harness clamp.

A458713


e.

Disconnect the EGR valve assembly connector.


f.

Remove the bolts, nuts and EGR valve with EGR cooler assembly.

(The illustrations are representative examples, and details may differ.)


Hide 25634 5.REMOVE EGR PIPE GASKET

a.
A465943

Remove the EGR pipe gasket from EGR valve adapter.


Hide 25685 6.REMOVE NO. 1 EGR COOLER GASKET

Hide 25620 7.REMOVE EGR VALVE ASSEMBLY

a.
A463793

Remove the 2 bolts and EGR valve assembly from EGR cooler assembly.


Hide 25627 8.REMOVE EGR VALVE GASKET

a.
A463794

Remove the EGR valve gasket from EGR valve assembly.