Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB (for TMC Made) › 2020.07–2020.09
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0430772 REAR AXLE HUB(for TMC Made) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for TMC Made)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)


Hide 89516D 4.CONNECT SKID CONTROL SENSOR WIRE

a.

Connect the skid control sensor wire assembly connector to the rear axle hub and bearing assembly.


Hide 42431D 5.INSTALL BRAKE DRUM

Hide 6.INSTALL REAR WHEEL

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for HV Model)

Hide 10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (for HV Model)

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART