Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Gasoline Model with Manual Air Conditioning System) › from 2020.07
RM36W0E _58 Vehicle Interior _088019 HEATING / AIR CONDITIONING _0420297 AIR CONDITIONING SYSTEM(for Gasoline Model with Manual Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Gasoline Model with Manual Air Conditioning System)  No Warm Air Comes Out  


DESCRIPTION

If cool air blows from the registers regardless of the temperature setting of the air conditioning system, the following factors may be the cause.

Symptom Factor
·

No warm air comes out

(Blower control is normal)

·

Outlet air temperature does not increase

(Blower control is normal)


·

Flow shutting valve

·

Engine coolant temperature (low)

·

Blockage in heater radiator unit sub-assembly

·

Quick heater assembly malfunction*1

·

Heater radiator unit sub-assembly malfunction



*1: w/ PTC Heater


PROCEDURE

1.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up This is the engine coolant temperature.
HINT:
·

After warming up the engine, the engine coolant temperature will be 75 to 100°C (167 to 212°F).

·

After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature will be approximately equal.

·

If the value is -40°C (-40°F), or higher than 135°C (275°F), the sensor circuit is open or shorted.

·

Check if the engine overheats if the value indicated is higher than 135°C (275°F).



Powertrain > Engine > Data List
Tester Display
Coolant Temperature
50003 372 205
OK:

After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.



Result:
Result Proceed to
OK A
NG (for 1KR-FE) B
NG (for M15A-FKS) C



A

2.CONFIRM MODEL

B

C

2.CONFIRM MODEL
a.

Choose the model to be inspected.


Result:
Result Proceed to
w/ PTC Heater A
LHD Models not equipped with PTC Heater B
RHD Models not equipped with PTC Heater C



A

3.CHECK QUICK HEATER ASSEMBLY

B

C

3.CHECK QUICK HEATER ASSEMBLY
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
PTC Heater Quick heater assembly Min.: 0
Max.: 3
-
Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
PTC Actual Driving Count Number quick heater assembly elements actually driven Min.: 0
Max.: 3
Number quick heater assembly elements actually driven PTC heater circuit malfunction
Body Electrical > Air Conditioner > Active Test
Active Test Display
PTC Heater
Data List Display
PTC Actual Driving Count
50004 450 5 276

b.

Check that the value of the Data List item PTC Heater changes in accordance with the set value of the Active Test item PTC Actual Driving Count.

OK:
GTS Operation Data List (PTC Actual Driving Count)
0 to 3 0 to 3



Result:
Proceed to
OK
NG



OK

NG