The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during clutch pedal switch removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION (for RHD)
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
55606
2.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
84520
3.REMOVE CLUTCH START SWITCH ASSEMBLY
| *A | for LHD |
| *B | for RHD |
Disconnect the clutch start switch assembly connector.
Remove the nut and clutch start switch assembly from the clutch pedal support sub-assembly.
To prevent damage to the clutch start switch assembly, make sure not to rotate it during removal.
4.REMOVE STEERING COLUMN ASSEMBLY (for RHD)
31453A
5.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN (for LHD)
31453A
6.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN (for RHD)
7.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY (for LHD)
8.REMOVE CLUTCH PEDAL SUPPORT ASSEMBLY (for RHD)
88280A
9.REMOVE CLUTCH SWITCH ASSEMBLY
| *A | for LHD |
| *B | for RHD |
Loosen the nut and remove the clutch switch assembly from the clutch pedal support sub-assembly.