Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER (for LHD) › 2020.07–2020.09
RM36W0E _52 Drivetrain _089426 CLUTCH _0430795 CLUTCH MASTER CYLINDER(for LHD) A

CLUTCH  CLUTCH MASTER CYLINDER(for LHD)  INSTALLATION  


PROCEDURE

Hide 31410 1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY

a.

Install a new clutch master cylinder gasket to the clutch master cylinder assembly.


b.

Install the clutch master cylinder assembly to the vehicle body with the 2 nuts.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


Hide 31453A 2.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN

Hide 31481 3.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C437877C01
1.844,2.99 2.156,3.188 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a 10 mm union nut wrench, connect the clutch master cylinder to flexible hose tube to the clutch master cylinder assembly.

Torque:
Specified Tightening Torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the clutch master cylinder to flexible hose tube.

·

Do not allow any foreign matter such as dirt or dust to enter the clutch master cylinder to flexible hose tube from the connecting part.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)




Hide 31434E 4.CONNECT NO. 1 CLUTCH RESERVOIR HOSE

a.
C437878C01
1.042,2.688 1.24,2.438 false 2.271,3.052 1.792,3.208 true 0.104,2.271 0.417,2.427 0.313,0.156 10 false *a 0.927,2.292 1.24,2.448 0.313,0.156 10 false *b 1.26,2.292 1.573,2.448 0.313,0.156 10 false *c 2.823,2.917 3.135,3.073 0.313,0.156 10 false *d 1.635,0.375 1.792,0.573 0.156,0.198 10 true A 1.615,3.125 1.927,3.281 0.313,0.156 10 false *e
*a View A
*b Front of Vehicle
*c Paint Mark (Front of Vehicle)
*d 0 to 2 mm (0 to 0.0787 in.)
*e Alignment Mark


Connect the No. 1 clutch reservoir hose to the clutch master cylinder assembly and slide the hose clip to secure it.

NOTICE:
·

Make sure that the alignment mark of the No. 1 clutch reservoir hose is with in the assembly mark on shown in the illustration.

·

Make sure that the claws of the hose clip are within the location shown in the illustration.




Hide 7.INSPECT FOR BRAKE FLUID LEAK