Home › Engine / Hybrid System › M15A-FXE (EMISSION CONTROL) › CANISTER (for No. 2) › from 2020.07
RM36W0E _51 Engine / Hybrid System _088663 M15A-FXE EMISSION CONTROL _0431173 CANISTER(for No. 2) A

M15A-FXE EMISSION CONTROL  CANISTER(for No. 2)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during canister (fuel suction plate sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Replacement of fuel pump Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

Hide 72693 2.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 58325E 3.REMOVE REAR FLOOR SERVICE HOLE COVER

Hide 77701W 4.DISCONNECT NO. 1 CANISTER OUTLET HOSE SUB-ASSEMBLY

Hide 58415Q 5.REMOVE NO. 1 REAR FLOOR BOARD

a.
A466956

Remove the bolt, 5 clips and No. 1 rear floor board from the vehicle.


Hide 6.REMOVE NO. 2 CHARCOAL CANISTER

a.
A466957

Disconnect the canister air tube from the No. 2 canister.

Click hereEngine / Hybrid System>M15A-FXE (FUEL)>FUEL SYSTEM>PRECAUTION


b.
A466958

Remove the nut.


c.

Disengage the 3 clamps to remove the No. 2 charcoal canister.