17410
1.SEPARATE FRONT EXHAUST PIPE ASSEMBLY
Disconnect the No. 2 heated oxygen sensor connector.
Disconnect the No. 2 heated oxygen sensor wire.
Remove the 2 bolts and 2 compression springs to separate the front exhaust pipe assembly from the exhaust manifold.
Remove the exhaust pipe gasket from the exhaust manifold.
89465
2.REMOVE HEATED OXYGEN SENSOR
17118
3.REMOVE MANIFOLD STAY
Remove the bolt, nut and manifold stay from the exhaust manifold and cylinder block sub-assembly.
82715W
4.REMOVE WIRING HARNESS CLAMP BRACKET
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the bolt and wiring harness clamp bracket from the cylinder head sub-assembly.
25760
5.REMOVE VACUUM TRANSMITTING HOSE ASSEMBLY (w/ Differential Pressure Sensor)
25706B
6.REMOVE NO. 1 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY (w/ Differential Pressure Sensor)
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the bolt.
Using a 17 mm union nut wrench, remove the No. 1 vacuum transmitting pipe sub-assembly from the exhaust manifold.
17140A
7.REMOVE EXHAUST MANIFOLD
Remove the 6 nuts and exhaust manifold from the cylinder head sub-assembly.
25586
8.REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR
Remove the 3 bolts and No. 1 manifold converter insulator from the exhaust manifold.
25587
9.REMOVE NO. 2 MANIFOLD CONVERTER INSULATOR
Remove the 2 bolts and No. 2 manifold converter insulator from the exhaust manifold.
17173
10.REMOVE EXHAUST MANIFOLD TO HEAD GASKET
Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
25628B
11.REMOVE INLET EGR GASKET
Remove the inlet EGR gasket from the cylinder head sub-assembly.