Home › Engine / Hybrid System › 1KR-FE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL › from 2020.07
RM36W0E _51 Engine / Hybrid System _091035 1KR-FE ENGINE MECHANICAL _0431328 FRONT CRANKSHAFT OIL SEAL A

1KR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11302A 1.INSTALL TIMING CHAIN COVER OIL SEAL

a.

Apply engine oil to the lip of a new timing chain cover oil seal.


b.
A322562N01
1.26,1.594 0.792,0.323 0.792,0.323 1.854,0.823 true 0.531,0.26 0.99,0.458 0.458,0.198 10 false SST 2.292,0.177 2.5,0.385 0.208,0.208 10 false - 2.844,0.167 3.052,0.375 0.208,0.208 10 false +

Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.

Standard Depth:

-0.5 to 1.0 mm (-0.0197 to 0.0394 in.)


SST
09223-22010  

NOTICE:

Do not tap in the timing chain cover oil seal at an angle.



Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.
A322563C02
0.917,2.719 1.25,2.719 true 0.406,0.208 0.719,0.594 true 1.438,0.156 1.646,0.583 true 0.969,2.875 1.156,3.052 0.188,0.177 10 true *c 1.698,2.948 1.917,3.115 0.219,0.167 10 true *d 0.625,2.646 0.896,2.813 0.271,0.167 10 true SST 0.219,0.125 0.406,0.302 0.188,0.177 10 false *a 1.281,0.083 1.5,0.25 0.219,0.167 10 false *b
*a key groove
*b key
*c Hold
*d Turn


Align the crankshaft timing gear key with the key groove of the crankshaft pulley.


b.

Using SST, hold the crankshaft pulley in place and tighten the crankshaft pulley set bolt.

SST
09960-10010  (09962-01000, 09963-01000)

Torque:
170 N*m (1734 kgf*cm, 125 ft.*lbf)


Hide 16361A 4.INSTALL FAN AND GENERATOR V BELT