The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the power window regulator motor removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
for 1KR-FE:
Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>REMOVAL
67673A
3.REMOVE REAR DOOR FRAME GARNISH
84810D
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
67603
5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68173B
6.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
68196B
7.REMOVE REAR DOOR BELT FRONT SEAL
68198
8.REMOVE REAR DOOR BELT REAR SEAL
67841E
9.REMOVE REAR DOOR SERVICE HOLE COVER (w/ Rear Speaker)
67841E
10.REMOVE REAR DOOR SERVICE HOLE COVER (w/o Rear Speaker)
68142C
11.REMOVE REAR DOOR GLASS RUN
67407E
12.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68103
13.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
14.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
85710F
15.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
Remove the 3 bolts and power window regulator motor assembly.
| *a | Protective Tape |
| *b | Drum |
Using a screwdriver with its tip wrapped in protective tape, carefully remove the power window regulator motor assembly while holding down the drum.