The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to neutral, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
4.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
17701
5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
6.REMOVE ECM
57543C
7.REMOVE CENTER NO. 1 FLOOR BRACE
51447D
8.REMOVE CENTER NO. 4 ENGINE UNDER COVER
74404A
9.REMOVE BATTERY CLAMP SUB-ASSEMBLY
17410
10.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58166A
11.REMOVE FRONT FLOOR COVER LH
58165C
12.REMOVE FRONT FLOOR COVER RH
Use the same procedure as for the LH side.
58151
13.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
58153
14.REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR
33820B
15.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the clip and disconnect the transmission control select cable from the floor shift shift lever assembly.
Disconnect the transmission control shift cable from the floor shift shift lever assembly.
Disengage the 2 claws and disconnect the transmission control cable assembly from the floor shift shift lever assembly.
Do not forcibly pull the transmission control cable assembly into the cabin.
Remove the 2 clips (A) to disconnect the transmission control cable assembly from the manual transaxle assembly.
Remove the 2 clips (B) to disconnect the transmission control cable assembly from the control cable bracket assembly.
Remove the nut.
Disengage the guide and disconnect the transmission control cable assembly from the vehicle body.
Remove the 2 nuts and transmission control cable assembly from the vehicle body.