Home › Drivetrain › K320 (MULTIDRIVE / CVT) › OIL COOLER › from 2020.07
RM36W0E _52 Drivetrain _087836 K320 MULTIDRIVE / CVT _0422060 OIL COOLER A

K320 MULTIDRIVE / CVT  OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission oil cooler removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of CVT fluid
w/ Stop and Start System:

Bleed air from oil pump (continuously variable transaxle assembly)


Stop and Start System (Click here)
ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide 51442C 2.REMOVE ENGINE UNDER COVER LH

Hide 3.DRAIN ENGINE COOLANT

Hide 4.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 16281N 5.DISCONNECT NO. 4 WATER BY-PASS HOSE

a.
C435490

Slide the hose clip and disconnect the No. 4 water by-pass hose from the transmission oil cooler.


Hide 16290F 6.DISCONNECT NO. 3 WATER BY-PASS HOSE ASSEMBLY

a.
C435491

Slide the hose clip and disconnect the No. 3 water by-pass hose assembly from the transmission oil cooler.


Hide 33493C 7.REMOVE TRANSMISSION OIL COOLER

a.
C428871

Remove the 3 bolts and transmission oil cooler from the transaxle housing.


b.
C428872

Remove the 2 O-rings from the transaxle housing.