Refer to DTC C051218
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C05121F | Right Rear Wheel Speed Sensor Circuit Intermittent | ·
The speed sensor signal is excessively noisy. ·
The calculated change in wheel speed is more than 980 m/s2 for 5*1 or 20*2 seconds or more. ·
The calculated change in wheel speed fluctuates between more than 500 m/s2 and less than -500 m/s2 for 5*1 or 20*2 seconds or more. ·
When the vehicle speed is low, excessive noise in the speed sensor pulse signal is detected 3 times or more within 0.005 second for 5*1 or 20*2 seconds or more. |
·
Rear speed sensor RH (rear axle hub and bearing assembly RH) ·
Rear speed sensor rotor RH (rear axle hub and bearing assembly RH) |
Brake |
*1: The stop light switch assembly is OFF.
*2: The stop light switch assembly is ON.
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
The rear speed sensor RH and rear speed sensor rotor RH are incorporated into the rear axle hub and bearing assembly RH.
If the rear speed sensor RH and/or rear speed sensor rotor RH need to be replaced, replace the rear axle hub and bearing assembly RH.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB (for TMMF Made)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT