Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB (for TMMF Made) › 2020.07–2021.11
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0430773 REAR AXLE HUB(for TMMF Made) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for TMMF Made)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42431D 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for Rear Drum Brake)

Hide 3.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY (for Rear Disc Brake)

a.
C427838

Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

NOTICE:
·

Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.

·

Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.




b.
C427839C02
1.344,1.448 1.76,1.323 true 1.083,1.365 1.323,1.583 0.24,0.219 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.

NOTICE:

Be careful not to damage the rear axle hub and bearing assembly or connector cover.



Hide 4.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for Rear Disc Brake)

Hide 5.REMOVE REAR DISC (for Rear Disc Brake)

Hide 89516D 6.DISCONNECT SKID CONTROL SENSOR WIRE (for Rear Drum Brake)

a.
C436149C01
1.396,1.427 1.646,1.427 true 1.167,1.323 1.385,1.542 0.219,0.219 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disconnect the skid control sensor wire connector from the rear axle hub and bearing assembly.

NOTICE:

Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.



Hide 42450B 7.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY (for Rear Drum Brake)

a.
C427837

Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.


Hide 8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY (for Rear Disc Brake)

a.
C427836

Remove the 4 bolts, rear axle hub and bearing assembly, rear disc brake dust cover sub-assembly and rear caliper support bracket from the rear axle beam assembly.

NOTICE:

Do not drop the rear disc brake dust cover sub-assembly and rear caliper support bracket.