Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0432441 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made)  C051223  Right Rear Wheel Speed Sensor Signal Stuck Low  


DESCRIPTION

Refer to DTC C051218

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>C051218

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C051223 Right Rear Wheel Speed Sensor Signal Stuck Low
·

When driving at a vehicle speed of 10 km/h (6 mph) or more, this wheel speed sensor signal output value is 2 km/h (1 mph) or less for 180 seconds or more.

·

When any of the wheel speeds reaches 14 km/h (9 mph), this wheel speed sensor signal output value is 2 km/h (1 mph) or less.

·

When compared to the other 3 wheels, an abnormally low speed is detected for this wheel speed sensor signal.


Rear speed sensor RH (rear axle hub and bearing assembly RH) Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>TEST MODE PROCEDURE


HINT:

The rear speed sensor RH is incorporated into the rear axle hub and bearing assembly RH.

If the rear speed sensor RH needs to be replaced, replace the rear axle hub and bearing assembly RH.


PROCEDURE

1.CHECK FREEZE FRAME DATA (WHEEL SPEED)
a.

Using the GTS, read the "FR Wheel Speed", "FL Wheel Speed", "RR Wheel Speed" and "RL Wheel Speed" of the Freeze Frame Data stored when the DTC C050623 was stored.

Chassis > Brake
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake > DTC(C051223) > Freeze Frame Data
Tester Display
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
50040 435 13,14,15,16 C051223

Result:
Result Proceed to
The value of RR Wheel Speed is 2 km/h (1 mph) or less when all other values are 10 km/h (6 mph) or more. A
The value of RR Wheel Speed is too low when all other values are 20 km/h (12 mph) or more. B



A

2.READ VALUE USING GTS (RR WHEEL SPEED)

B

REPLACE REAR AXLE HUB & BEARING ASSEMBLY RH

2.READ VALUE USING GTS (RR WHEEL SPEED)

Pre-procedure1

a.

Start the engine.


Procedure1

b.

Select the Data List on the GTS.

Chassis > Brake > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0.0 km/h (0.0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
Chassis > Brake > Data List
Tester Display
RR Wheel Speed
50003 435 15

c.

Perform a road test.


d.

Check that the value of RR Wheel Speed changes in accordance with vehicle speed when accelerating from 0 to 20 km/h (0 to 12 mph).

OK:

The value of RR Wheel Speed changes in accordance with vehicle speed.


HINT:

If the result of the road test is within the specified range, it is possible that this DTC was stored due to a particular situation such as brake drag, wheelspin or wheel lockup.



Post-procedure1

e.

Turn the ignition switch off.


Result:
Proceed to
OK
NG



OK

NG

REPLACE REAR AXLE HUB & BEARING ASSEMBLY RH