The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication.
Yaw rate and acceleration sensor (airbag sensor assembly) installation abnormality.
Acceleration sensor signal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C052096 | Multi-axis Acceleration Sensor Module "A" Component Internal Failure | ·
Longitudinal acceleration signal does not fulfill execution requirements for 0.2 second or more. ·
Lateral acceleration signal does not fulfill execution requirements for 0.5 second or more. |
·
Acceleration sensor (airbag sensor assembly) installation ·
Acceleration sensor (airbag sensor assembly) |
Brake |
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform yaw rate and acceleration sensor zero point calibration and store system information memorization after performing "Reset Memory".
Using the GTS, read the "Lateral G" and "Forward and Rearward G" of the Freeze Frame Data stored when the DTC C052096 was stored.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Lateral G | Lateral G | Min.: -25.105 m/s2, Max.: 24.908 m/s2 | Turning right: -25.105 to 0.000 m/s2
Turning left: 0.000 to 24.908 m/s2 |
During turning: Changes in proportion with lateral acceleration |
| Forward and Rearward G | Forward and rearward G | Min.: -25.105 m/s2, Max.: 24.908 m/s2 | During deceleration: -25.105 to 0.000 m/s2
During acceleration: 0.000 to 24.908 m/s2 |
During acceleration/deceleration: Changes in proportion with acceleration |
| Tester Display |
|---|
| Lateral G |
| Forward and Rearward G |
| Result | Proceed to |
|---|---|
| The value of Lateral G or Forward and rearward G is less than -14.6 m/s2 or more than 14.6 m/s2. | A |
| Other than above. | B |
A
B
Using the GTS, read the "Lateral G" and "Vehicle Speed" of the Freeze Frame Data stored when the DTC C052096 was stored.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Lateral G | Lateral G | Min.: -25.105 m/s2, Max.: 24.908 m/s2 | Turning right: -25.105 to 0.000 m/s2
Turning left: 0.000 to 24.908 m/s2 |
During turning: Changes in proportion with lateral acceleration |
| Vehicle Speed | Vehicle speed (vehicle speed used for each control) | Min.: 0.0 km/h (0 mph), Max.: 6553.5 km/h (4072 mph) | Vehicle stopped: 0.0 km/h (0.0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display |
|---|
| Lateral G |
| Vehicle Speed |
| Result | Proceed to |
|---|---|
| The value of Vehicle speed is 0 km/h (0 mph) and the value of Lateral G is less than -7 m/s2 or more than 7 m/s2. | A |
| Other than above. | B |
A
B
Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.
The yaw rate and acceleration sensor (airbag sensor assembly) is not installed in a tilted position.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION