Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › 2020.07–2020.09
RM36W0E _58 Vehicle Interior _088020 SUPPLEMENTAL RESTRAINT SYSTEMS _0421877 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the airbag sensor assembly, make sure to perform ECU configuration.

·

After performing the ECU configuration procedure, make sure to perform the initialization procedure for when the cable has been disconnected and reconnected to the negative (-) auxiliary battery terminal.



PROCEDURE

Hide 89170 1.INSTALL AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.

temporarily install the airbag sensor assembly with the 3 bolts.


d.
B583386N01
2.344,0.333 2.5,0.531 0.156,0.198 10 true 1 2.833,1.25 2.99,1.448 0.156,0.198 10 true 2 0.677,1.719 0.833,1.917 0.156,0.198 10 true 3

Install the 3 bolts in the order shown in the illustration.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the ignition switch is first turned ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.




e.
B583387C01
0,0 0,0 false
V113147

Push in the Lock Lever


Connect the 2 connectors and push in the lock lever to lock the 2 connectors.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



f.

Check that there is no looseness in the installed parts of the airbag sensor assembly.


Hide 58510D 2.CONNECT FRONT FLOOR CARPET ASSEMBLY

a.

Engage the hooks to connect the front floor carpet assembly as shown in the illustration.

B583388C01
0,0 0,0 false
V113147

Connect in this Direction - -



b.

Install the 2 clips.


Hide 58910C 3.INSTALL REAR CONSOLE BOX ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 9. ZERO POINT CALIBRATION

a.

When the airbag sensor assembly is replaced, perform zero point calibration.

Click hereGeneral>SETUP>WHEN REPLACING OR REMOVING/INSTALLING PARTS>WORK PROCEDURE