Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0432441 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made)  C052F14  ABS Pump Motor Supply Voltage Circuit Short to Ground or Open  C142719  ABS Pump Motor Circuit Current Above Threshold  


DESCRIPTION

The ABS motor relay is built into the brake actuator assembly.

When the skid control ECU (brake actuator assembly) operates ABS, TRC, VSC or brake assist, the ABS motor relay turns ON and drives the motor pump built into the brake actuator assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C052F14 ABS Pump Motor Supply Voltage Circuit Short to Ground or Open When the pump motor is operation has stopped, the pump motor power source voltage is approximately 6.0 V or less for 1.8 seconds or more. Skid control ECU (brake actuator assembly) Brake
C142719 ABS Pump Motor Circuit Current Above Threshold
·

When the pump motor is operating, a short in the pump motor drive circuit is detected 3 times consecutively.

·

When the pump motor is operating, a pump motor stuck condition is detected 10 times consecutively.


Skid control ECU (brake actuator assembly) Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform yaw rate and acceleration sensor zero point calibration and store system information memorization.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>UTILITY


PROCEDURE

1.CHECK VEHICLE TYPE
a.

Check the vehicle specification.


Result:
Result Proceed to
LHD A
RHD B



A

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

B