The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the front door belt moulding removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
for 1KR-FE:
Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>REMOVAL
87940
3.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY (for TMC Made)
87940
4.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY (for TMMF Made)
67832
5.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
6.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68210C
7.REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
|
Protective Tape |
Apply protective tape around the front door glass outer weatherstrip assembly.
|
Remove in this Direction |
Disengage the claws to remove the front door glass outer weatherstrip assembly as shown in the illustration.