The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) performs sensitivity compensation of the longitudinal acceleration signal based on the steering sensor, wheel speed sensor and yaw rate sensor signals, and stores the following DTCs if a malfunction is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C05511C | Longitudinal Acceleration Sensor Circuit Voltage Out of Range | ·
While the vehicle is being driven at a constant speed and the slowest wheel speed is 3 km/h (2 mph) or less, the longitudinal acceleration signal output value is outside the range of -0.8 to 0.8 g for more than a certain period of time. ·
When the vehicle is being driven at a constant speed, the longitudinal acceleration signal output value is outside the range of -0.2 to 0.5 g for more than a certain period of time. ·
When the vehicle speed is 70 km/h (43 mph) or more, the longitudinal acceleration signal output value and the control value calculated by the skid control ECU both have absolute values of 0.2 g or more, and they are in the opposite phase. |
·
Acceleration sensor (airbag sensor assembly) ·
Acceleration sensor (airbag sensor assembly) installation |
Brake |
| C05512A | Longitudinal Acceleration Sensor Signal Stuck In Range | Abnormal result when comparing the longitudinal acceleration value calculated by the skid control ECU with the longitudinal acceleration signal output value. | ·
Acceleration sensor (airbag sensor assembly) ·
Acceleration sensor (airbag sensor assembly) installation |
Brake |
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.
The yaw rate and acceleration sensor (airbag sensor assembly) is not installed in a tilted position.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT