The master cylinder pressure sensor is connected to the skid control ECU in the brake actuator assembly.
The DTC is output when the calibration has not been completed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C056054 | Brake Pressure Sensor "A" Missing Calibration | Zero point calibration of master cylinder pressure sensor undone. | Skid control ECU (brake actuator assembly) | Brake |
After replacing the skid control ECU (brake actuator assembly), perform yaw rate and acceleration sensor zero point calibration and system information memorization.
Operate the GTS, perform calibration.
| Tester Display |
|---|
| Calibration |
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
None
Procedure1
Operate the GTS to clear the codes.
Post-procedure1
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Procedure1
Operate the GTS to read the DTCs.
Check if the same DTC is output.
Post-procedure1
Turn the ignition switch off.
| Result | Proceed to |
|---|---|
| C056054 is not output | A |
| C056054 is output | B |
A
B
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model TMMF Made RHD)>REMOVAL