When the operating time of ABS control is detected to be excessive, the skid control ECU (brake actuator assembly) stores the following DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C141A00 | ABS Time too Long | Operating time of ABS control exceeds 18 seconds. | ·
Front speed sensors ·
Speed sensor installation ·
Front speed sensor rotors (front axle hub sub-assemblies) ·
Rear speed sensors (rear axle hub and bearing assemblies) ·
Rear speed sensor rotors (rear axle hub and bearing assemblies) ·
Skid control ECU (brake actuator assembly) |
Brake |
After replacing the skid control ECU (brake actuator assembly), perform yaw rate and acceleration sensor zero point calibration and store system information memorization.
The front speed sensor rotor is incorporated into the front axle hub sub-assembly.
If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.
The rear speed sensor and rear speed sensor rotor are incorporated into the rear axle hub and bearing assembly.
If the rear speed sensor and rear speed sensor rotor need to be replaced, replace the rear axle hub and bearing assembly.
Check that the proper skid control ECU (brake actuator assembly) is installed.
Proper skid control ECU (brake actuator assembly) is installed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for Gasoline Model TMMF Made RHD)>REMOVAL
Perform system information memorization.
| Tester Display |
|---|
| Reset Memory |
| Tester Display |
|---|
| Calibration |
If a new skid control ECU (brake actuator assembly) was installed, C121054 and C051D54 are output before "Calibration" is performed.
After performing "Reset Memory" using the GTS to clear the memorized value of the skid control ECU (brake actuator assembly), DTCs C121054 and C051D54 will be stored until system information memorization is performed.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
None
Procedure1
Operate the GTS to clear the codes.
Post-procedure1
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
Procedure1
Operate the GTS to read the DTCs.
Check if the same DTC is output.
Post-procedure1
None
| Result | Proceed to |
|---|---|
| C141A00 is not output | A |
| C141A00 is output | B |
A
B
Using the GTS, perform a Dealer Mode (Signal Check) inspection sensor check and check that speed sensor Dealer Mode (Signal Check) inspection items change from incomplete to complete.
| Tester Display |
|---|
| Signal Check |
Speed sensor Dealer Mode (Signal Check) inspection items change from incomplete to complete.
| Result | Proceed to |
|---|---|
| OK (for Front) | A |
| OK (for Rear) | B |
| NG | C |
When cleaning the front speed sensor, make sure to clean the installation hole before installation.
Do not use parts cleaner when cleaning the front speed sensor rotor.
A
B
C