Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0432441 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model TMMF Made)  C145F12  ABS Solenoid Control Module Circuit Short to Battery  C145F14  ABS Solenoid Control Module Circuit Short to Ground or Open  C14DA16  ABS Solenoid Supply Voltage Circuit Voltage Below Threshold  C14DA17  ABS Solenoid Supply Voltage Circuit Voltage Above Threshold  C14DA1C  ABS Solenoid Supply Voltage Circuit Voltage Out of Range  


DESCRIPTION

The ABS solenoid relay is built into the skid control ECU in the brake actuator assembly.

The ABS solenoid relay supplies power to the holding solenoid and reduction solenoid.

The skid control ECU (brake actuator assembly) performs self-checks and relay drive checks to detect malfunctions in the ABS solenoid relay.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C145F12 ABS Solenoid Control Module Circuit Short to Battery When the ABS solenoid relay is commanded to turn OFF, the self-check function detects an abnormal voltage in the ABS solenoid relay drive circuit. Skid control ECU (brake actuator assembly) Brake
C145F14 ABS Solenoid Control Module Circuit Short to Ground or Open When the ABS solenoid relay is commanded to turn OFF, the self-check function detects an abnormal startup in the ABS solenoid relay drive circuit. Skid control ECU (brake actuator assembly) Brake
C14DA16 ABS Solenoid Supply Voltage Circuit Voltage Below Threshold The ABS solenoid voltage is less than the threshold value for 0.08 second or more. Skid control ECU (brake actuator assembly) Brake
C14DA17 ABS Solenoid Supply Voltage Circuit Voltage Above Threshold When the ABS solenoid relay is commanded to turn OFF, the ABS solenoid voltage is more than 3.0 V for 0.08 second or more. Skid control ECU (brake actuator assembly) Brake
C14DA1C ABS Solenoid Supply Voltage Circuit Voltage Out of Range
·

ABS solenoid power source circuit voltage continuously deviates from 8.5 V.

·

Difference between ABS solenoid power source circuit voltage and +BS terminal voltage exceeds the threshold.


Skid control ECU (brake actuator assembly) Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform yaw rate and acceleration sensor zero point calibration and store system information memorization.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model TMMF Made)>UTILITY


PROCEDURE

1.CHECK VEHICLE TYPE
a.

Check the vehicle specification.


Result:
Result Proceed to
LHD A
RHD B



A

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)

B