Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › 2020.07–2021.11
RM36W0E _54 Brake _089430 PARKING BRAKE _0433905 ELECTRIC PARKING BRAKE SYSTEM J

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  Electric Parking Brake System AUTO Function Circuit  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives shift position signals from the hybrid vehicle control ECU via CAN communication to control the electric parking brake system AUTO function (shift-linked function).

The electric parking brake system AUTO function (shift-linked function) is automatically disabled when the ignition switch is ON, the brake pedal is depressed and the shift lever is moved out of P. Then, if the shift lever is moved to P, the AUTO function (shift-linked function) automatically operates to apply the electric parking brake.

WIRING DIAGRAM

C396297E09
0.958,0.656 3.229,0.844 2.271,0.188 10 false Hybrid Vehicle Control ECU 0.938,1.063 2.354,1.271 1.417,0.208 10 false - Shift Position Signal 5.479,1.49 7.052,1.979 1.573,0.49 10 false Skid Control ECU (Brake Actuator Assembly) 1.25,2.281 2.948,2.469 1.698,0.188 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

The AUTO function (shift-linked function) will not be automatically disabled when the ignition switch is ON, the brake pedal is depressed and the shift lever is moved out from P if the electric parking brake switch assembly is moved to the engage side. The AUTO function (shift-linked function) will not automatically operate to apply the electric parking brake when the shift lever is moved to P if the electric parking brake switch assembly is moved to the release side.

·

To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the skid control ECU (brake actuator assembly), perform calibration (brake pedal stroke sensor assembly zero point calibration, system information memorization, and yaw rate and acceleration sensor zero point calibration) after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made)>UTILITY

·

When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.



PROCEDURE

1.CHECK DTC (HYBRID CONTROL SYSTEM)
a.

Check for DTCs.

Powertrain > Hybrid Control > Trouble Codes
50001 397
Result:
Result Proceed to
DTC is not output A
DTC is output B




A

B