The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front door lock assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
for 1KR-FE:
Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
74232
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)
74231
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
67656
6.REMOVE FRONT DOOR TRIM GARNISH
67602
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
68172A
8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
67838A
9.REMOVE FRONT DOOR VENT SEAL
67856B
10.REMOVE FRONT DOOR PANEL PROTECTOR
67832
11.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68151C
13.REMOVE FRONT DOOR GLASS RUN
67404F
14.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
69220
15.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)
16.REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)
69040A
17.REMOVE FRONT DOOR LOCK ASSEMBLY
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Disconnect the front door lock open rod as shown in the illustration.
Remove the front door lock assembly.
When reusing the front door lock assembly:
Remove the door lock wiring harness seal from the front door lock assembly.
69720D
18.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.
Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.
69720D
19.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.
Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.
69760B
20.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)
Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.
69760B
21.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)
Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.