Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2020.07–2021.04
RM36W0E _56 Audio / Visual / Telematics _088657 PARK ASSIST / MONITORING _0434307 REAR VIEW MONITOR SYSTEM J

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  Image from Camera for Rear View Monitor is Abnormal  


DESCRIPTION

The display signal from the rear television camera assembly is transmitted to the radio and display receiver assembly.

WIRING DIAGRAM

E395850E25
5.708,0.552 6.167,0.75 0.458,0.198 10 false CA+ 5.771,1.063 6.229,1.26 0.458,0.198 10 false V+ 5.76,1.521 6.219,1.719 0.458,0.198 10 false V- 5.729,1.917 6.188,2.115 0.458,0.198 10 false CGND 5.438,0.531 5.896,0.729 0.458,0.198 10 false 30 5.458,1 5.917,1.198 0.458,0.198 10 false 28 5.458,1.479 5.917,1.677 0.458,0.198 10 false 29 5.458,1.938 5.917,2.135 0.458,0.198 10 false 27 3.469,2.417 4.135,2.615 0.667,0.198 10 false * 1.51,0.552 1.969,0.75 0.458,0.198 10 false 6 1.521,1.01 1.979,1.208 0.458,0.198 10 false 3 1.531,1.479 1.99,1.677 0.458,0.198 10 false 2 1.521,1.938 1.979,2.135 0.458,0.198 10 false 5 1.125,0.688 1.583,0.885 0.458,0.198 10 false CB+ 1.125,1.094 1.583,1.292 0.458,0.198 10 false CV+ 1.156,1.594 1.615,1.792 0.458,0.198 10 false CV- 1,2.031 1.458,2.229 0.458,0.198 10 false CGND 5.24,2.813 5.698,3.01 0.458,0.198 10 false H80 5.229,2.99 6.917,3.354 1.688,0.365 10 false Radio and Display Receiver Assembly 0.26,2.51 0.719,2.708 0.458,0.198 10 false Y1 0.24,2.698 2.844,2.99 2.604,0.292 10 false Rear Television Camera Assembly 5.719,2.417 6.177,2.615 0.458,0.198 10 false CSLD 5.458,2.281 5.917,2.479 0.458,0.198 10 false 26 0.625,3.375 1.396,3.563 0.771,0.188 10 false *: Shielded

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the radio and display receiver assembly, always replace it with a new one.

If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly may not operate normally.

w/ Navigation System:

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION

w/ Audio and Visual System:

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>PRECAUTION




PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the H80 radio and display receiver assembly connector.


b.

Disconnect the Y1 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H80-30 (CA+) - Y1-6 (CB+) Always Below 1 Ω
H80-28 (V+) - Y1-3 (CV+) Always Below 1 Ω
H80-27 (CGND) - Y1-5 (CGND) Always Below 1 Ω
H80-29 (V-) - Y1-2 (CV-) Always Below 1 Ω
H80-30 (CA+) or Y1-6 (CB+) - Body ground Always 10 kΩ or higher
H80-28 (V+) or Y1-3 (CV+) - Body ground Always 10 kΩ or higher
H80-27 (CGND) or Y1-5 (CGND) - Body ground Always 10 kΩ or higher
H80-29 (V-) or Y1-2 (CV-) - Body ground Always 10 kΩ or higher
H80-26 (CSLD) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
a.

Remove the radio and display receiver assembly with its connectors still connected.


E404546C14
5.552,1.146 6.177,1.396 0.625,0.25 3.156,0.427 3.427,0.427 3.427,0.427 3.792,1.625 true 3.333,2.438 3.604,2.438 3.604,2.438 3.906,1.625 true 4.198,1.625 4.469,0.344 4.469,0.344 4.708,0.344 true 5.719,1.177 6.177,1.375 0.458,0.198 10 false H80 4.802,0.281 5.396,0.49 0.594,0.208 10 false CGND 3.135,2.354 3.729,2.563 0.594,0.208 10 false V- 2.875,0.354 3.469,0.563 0.594,0.208 10 false CA+ 1.063,0.646 1.438,0.99 0.375,0.344 10 false *a
*a Component with harness connected
(Radio and Display Receiver Assembly)
- -


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H80-29 (V-) - Body ground Always Below 1 Ω
H80-27 (CGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
H80-30 (CA+) - Body ground Ignition switch ACC 5.5 to 7.05 V



Result:
Proceed to
OK
NG



OK

3.CHECK REAR TELEVISION CAMERA ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.CHECK REAR TELEVISION CAMERA ASSEMBLY
a.

Remove the radio and display receiver assembly with its connectors still connected.

E404549C09
5.802,1.198 6.219,1.531 0.417,0.333 4.573,3.802 4.74,4.417 4.74,4.417 4.938,4.417 true 4.156,4.396 4.292,4.396 4.292,4.396 4.469,3.854 true 4.156,1.646 4.427,0.448 4.427,0.448 4.625,0.448 true 2.031,3.906 2.198,4.521 2.198,4.521 2.396,4.521 true 1.625,4.5 1.76,4.5 1.76,4.5 1.938,3.958 true 3.563,0.365 3.698,0.365 3.698,0.365 3.979,1.667 true 3.729,3.49 4.188,3.688 0.458,0.198 10 false GND 1.198,3.5 1.656,3.698 0.458,0.198 10 false GND 1.448,4.427 1.906,4.625 0.458,0.198 10 false *d 2.438,4.427 2.896,4.625 0.458,0.198 10 false *e 3.99,4.313 4.448,4.51 0.458,0.198 10 false *d 4.948,4.333 5.406,4.531 0.458,0.198 10 false *e 4.667,0.385 5.302,0.583 0.635,0.198 10 false CGND 3.302,0.313 3.938,0.51 0.635,0.198 10 false V+ 5.875,1.271 6.24,1.5 0.365,0.229 10 false H80 1.146,0.396 1.604,0.594 0.458,0.198 10 false *a 1.125,2.781 1.583,2.979 0.458,0.198 10 false *b 3.906,2.76 4.365,2.958 0.458,0.198 10 false *c
*a Component with harness connected
(Radio and Display Receiver Assembly)
*b Waveform 1
*c Waveform 2 *d Synchronization Signal
*e Video Waveform - -



b.

Check the waveform of the rear television camera assembly using an oscilloscope.

HINT:
·

A waterproof connector is used for the television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.

·

The video waveform changes according to the image sent by the rear television camera assembly.



Item Content
Terminal No. (Symbol) H80-28 (V+) - H80-27 (CGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Waveform 1: Ignition switch ON, shift lever in R, camera lens not covered, displaying an image
Waveform 2: Ignition switch ON, shift lever in R, camera lens covered, blacking out screen

OK:

Waveform is as shown in the illustration.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

4.CHECK REAR TELEVISION CAMERA ASSEMBLY
4.CHECK REAR TELEVISION CAMERA ASSEMBLY
a.

Replace the rear television camera assembly with a new or known good one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA>REMOVAL


b.

Check if the same malfunction recurs when the rear view monitor screen is displayed.

OK:

Malfunction does not reoccur (returns to normal).



Result:
Proceed to
OK
NG



OK

END (REAR TELEVISION CAMERA ASSEMBLY WAS DEFECTIVE)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY