If there is an open in a speaker circuit, the telephone transceiver assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the telephone transceiver assembly or front No. 3 speaker assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1AC07F | Speaker Cable Connection Actuator Stuck Off | The malfunction is detected in the telephone speaker circuit for approximately 10 seconds or more. | ·
Front No. 3 speaker assembly ·
Telephone transceiver assembly ·
Harness or connector |
When replacing the telephone transceiver assembly, make sure to replace it with a new one.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON and wait for 10 seconds or more.
Check for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1AC07F is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Disconnect the I1 front No. 3 speaker assembly connector.
Disconnect the H84 telephone transceiver assembly connector.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I1-4 (+) - H84-3 (SPO+) | Always | Below 1 Ω |
| I1-2 (-) - H84-4 (SPO-) | Always | Below 1 Ω |
| I1-4 (+) or H84-3 (SPO+) - Body ground | Always | 10 kΩ or higher |
| I1-2 (-) or H84-4 (SPO-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the No. 3 front speaker assembly.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON and wait for 10 seconds or more.
Check for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1AC07F is output | B |
A
B
Replace the telephone transceiver assembly with a new one.
| Proceed to |
|---|
| NEXT |
NEXT