This DTC is stored when the telephone transceiver assembly detects one of the following:
The mobilephone battery voltage drops or the mobilephone battery malfunctions.
The mobilephone battery temperature is (temporarily) high.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15CC49 | Backup Battery Internal Electronic Failure | Mobilephone battery malfunction | ·
Mobilephone battery ·
Telephone transceiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System (for e-Call).
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>PRECAUTION
When replacing the telephone transceiver assembly, make sure to replace it with a new one.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B15CC49 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Replace the mobilephone battery with a normal one and check if the same problem occurs again.
Click hereAudio / Visual / Telematics>TELEMATICS>MAYDAY BATTERY>REMOVAL
After replacing the mobilephone battery, perform initialization.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B15CC49 is output | B |
A
B
Replace the telematics transceiver.
| Proceed to |
|---|
| NEXT |
NEXT