This procedure is for troubleshooting when the slip indicator light remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication.
The slip indicator light blinks during VSC and/or TRC operation.
If a malfunction is detected, the slip indicator light comes on to warn the driver.
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Using the GTS, check for Vehicle Control History.
| Tester Display |
|---|
| Vehicle Control History (RoB) |
If vehicle control history is stored when the electronically controlled brake system and electric parking brake system are suspended, the slip indicator light illuminates.
| Result | Proceed to |
|---|---|
| There is no vehicle control history for when the electronically controlled brake system and electric parking brake system were suspended. | A |
| There is vehicle control history for when the electronically controlled brake system and/or electric parking brake system were suspended. | B |
A
B
After performing troubleshooting and repair regarding vehicle control history, clear the vehicle control history.
Perform the Active Test of the combination meter assembly using the GTS.
| Tester Display |
|---|
| Slip Warning |
Check the combination meter assembly.
The slip indicator light turns on or off in accordance with GTS operation.
| Proceed to |
|---|
| OK |
| NG |
OK
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model TMMF Made RHD)>REMOVAL
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for HV Model LHD)>REMOVAL
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING