Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made) › 2020.07–2021.11
RM36W0E _54 Brake _088016 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0435240 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model TMMF Made)  C052C11  ABS Pump Motor Control Circuit Short to Ground  C052C13  ABS Pump Motor Control Circuit Open  C052F14  ABS Pump Motor Supply Voltage Circuit Short to Ground or Open  C142719  ABS Pump Motor Circuit Current Above Threshold  


DESCRIPTION

The ABS motor relay is built into the brake actuator assembly.

When the skid control ECU (brake actuator assembly) operates ABS, TRC, VSC, brake hold or brake assist, the ABS motor relay turns ON and drives the motor pump built into the brake actuator assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C052C11 ABS Pump Motor Control Circuit Short to Ground When the voltage at terminal +BM is between 9.6 and 16.4 V, a short to ground in the ABS motor drive circuit is detected during the self test. Skid control ECU (brake actuator assembly) Brake
C052C13 ABS Pump Motor Control Circuit Open An open in the ABS motor drive circuit is detected during the self test. Skid control ECU (brake actuator assembly) Brake
C052F14 ABS Pump Motor Supply Voltage Circuit Short to Ground or Open
·

When the pump motor is turned off after operating, 0.6 V or more is detected at the pump motor for 0.48 seconds or more.

·

The power supply of the ABS motor relay is less than 5 V for 0.15 seconds or more.


Skid control ECU (brake actuator assembly) Brake
C142719 ABS Pump Motor Circuit Current Above Threshold
·

When the ABS motor relay is operating, an overload in the ABS motor relay is detected for 0.06 seconds or more.

·

When the ABS motor relay is operating, a short in the pump motor drive circuit is detected for 0.06 seconds or more.


Skid control ECU (brake actuator assembly) Brake

CAUTION / NOTICE / HINT

NOTICE:

After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model TMMF Made)>UTILITY


PROCEDURE

1.CONFIRM MODEL
a.

Choose the model to be inspected.


Result:
Result Proceed to
for RHD A
for LHD B



A

2.REPLACE BRAKE ACTUATOR ASSEMBLY

B

3.REPLACE BRAKE ACTUATOR ASSEMBLY
2.REPLACE BRAKE ACTUATOR ASSEMBLY

NEXT

END

3.REPLACE BRAKE ACTUATOR ASSEMBLY

NEXT

END