The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during meter mirror sub-assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
55302C
1.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
55084E
2.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
83108
3.REMOVE METER MIRROR SUB-ASSEMBLY
Disconnect the connector.
Remove the 2 nuts and bolt.
Disengage the guide to remove the meter mirror sub-assembly.