Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD) › 2020.07–2020.09
RM36W0E _59 Vehicle Exterior _088480 DOOR / HATCH _0443172 HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 2.REMOVE FRONT BUMPER ASSEMBLY

Hide 16681A 3.REMOVE RADIATOR UPPER AIR GUIDE PLATE

Hide 53875A 4.REMOVE FRONT FENDER LINER RH

Hide 53510 5.REMOVE HOOD LOCK ASSEMBLY

a.

w/ Engine Hood Courtesy Switch:

i.
B594321C03
1.125,0.646 1.385,0.385 true 1.927,0.74 2.188,0.479 true 1.417,0.26 1.635,0.469 0.219,0.208 10 true *a 2.219,0.365 2.438,0.573 0.219,0.208 10 true *b
*a Clamp
*b guide


Disconnect the connector.


ii.

Disengage the clamp and guide.



b.

Remove the 3 bolts.


c.
B594324

Disengage the guide to disconnect the hood lock control cable assembly, and remove the hood lock assembly.


Hide 55606 6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 53601 7.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 53601 8.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B576027

Disengage the guide.


b.

Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.


Hide 53630 9.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Disconnect the hood lock control cable assembly from the clamps.

B594326C01
5.646,2 6.063,2 true 6.094,1.906 6.323,2.104 0.229,0.198 10 true *a
*a Grommet - -



b.

Disengage the grommet.


c.

Pull the hood lock control cable assembly from the engine compartment to remove it.