Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK (for 3 Door) › from 2020.09
RM36W0E _58 Vehicle Interior _088479 DOOR LOCK _0447251 FRONT DOOR LOCK(for 3 Door) A

DOOR LOCK  FRONT DOOR LOCK(for 3 Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front door with motor lock assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the power switch is turned to on (IG), the servo motor standard position is recognized. -


·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>G16E-GTS AUXILIARY BATTERY>REMOVAL

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 67492A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 74232 4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Hide 74231 5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Hide 67656 6.REMOVE FRONT DOOR TRIM GARNISH

Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68172A 8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67832 9.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 69220 10.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)

Hide 11.REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

Hide 69040A 12.REMOVE FRONT DOOR WITH MOTOR LOCK ASSEMBLY

a.
B584472

Disconnect the connector.


b.

Using a T30 "TORX" socket wrench, remove the 3 screws.


c.
B584473

Disconnect the front door lock open rod as shown in the illustration.


d.

Remove the front door with motor lock assembly.


e.

When reusing the front door with motor lock assembly:

i.
B584474

Remove the door lock wiring harness seal from the front door with motor lock assembly.



Hide 69720D 13.REMOVE FRONT DOOR LOCK OPEN LEVER REMOTE CONTROL CABLE (w/o Double Locking System)

a.
B584475C01
2.542,0.885 1.792,0.333 true 1.583,0.177 1.792,0.396 0.208,0.219 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


b.
B584476

Disengage the guide to remove the front door lock open lever remote control cable from the front door with motor lock assembly.


Hide 69720D 14.REMOVE FRONT DOOR LOCK OPEN LEVER REMOTE CONTROL CABLE (w/ Double Locking System)

a.
B584478C01
2.875,0.833 2.438,0.917 true 2.917,0.698 3.125,0.917 0.208,0.219 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.


b.
B584479

Disengage the guide to remove the front door lock open lever remote control cable from the front door with motor lock assembly.


Hide 69760B 15.REMOVE FRONT DOOR LOCK/UNLOCK KNOB INSIDE LOCKING CABLE (w/o Double Locking System)

a.
B584477

Disengage the guide to remove the front door lock/unlock knob inside locking cable from the front door with motor lock assembly.


Hide 69760B 16.REMOVE FRONT DOOR LOCK/UNLOCK KNOB INSIDE LOCKING CABLE (w/ Double Locking System)

a.
B584480

Disengage the guide to remove the front door lock/unlock knob inside locking cable from the front door with motor lock assembly.