The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
for 5 Door:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for 5 Door)>REMOVAL
for 3 Door:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for 3 Door)>REMOVAL
88211B
2.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
Disconnect the connector.
|
Bolt |
|
Screw |
Remove the 2 bolts and screw.
Disengage the guides to remove the millimeter wave radar sensor assembly.
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.