Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
62472A
1.REMOVE INNER ROOF SIDE GARNISH
62412B
2.REMOVE CENTER PILLAR UPPER GARNISH
62452
3.REMOVE ROOF SIDE INNER GARNISH
62362
4.REMOVE FRONT ROOF SIDE RAIL WEATHERSTRIP RETAINER
62720A
5.REMOVE QUARTER WINDOW ASSEMBLY
for RH Side:
Disconnect the connector.
w/ Glass Breakage Sensor:
Disconnect the connector and disengage the clamp.
|
Protective Tape |
Apply protective tape to the area around the installation position of the quarter window assembly on the vehicle body to prevent it from being scratched.
| *a | Cut |
Using a knife, cut off the moulding as shown in the illustration.
| *a | Piano Wire |
| *b | Clip |
Pass a piano wire between the vehicle body and quarter window assembly from the interior.
Tie both wire ends to wooden blocks or similar objects that can serve as handles.
Cut off the adhesive by pulling the piano wire around the quarter window assembly.
When separating the quarter window assembly, be careful not to damage the paint or interior and exterior ornaments.
Using suction cups, disengage the clips to remove the quarter window assembly.
Be careful not to drop the quarter window assembly.