Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for 5 Door Front Side) › from 2020.09
RM36W0E _59 Vehicle Exterior _088018 WINDOW / GLASS _0447335 POWER WINDOW REGULATOR MOTOR(for 5 Door Front Side) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for 5 Door Front Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 85710E 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.

Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.


b.

Install the power window regulator motor assembly with the 3 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 2.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Hide 68101 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67831 4.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67855B 5.INSTALL FRONT DOOR PANEL PROTECTOR

Hide 67837A 6.INSTALL FRONT DOOR VENT SEAL

Hide 68171B 7.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67601 8.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67655 9.INSTALL FRONT DOOR TRIM GARNISH

Hide 74232 10.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Hide 74231 11.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Hide 67491A 12.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 13.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 14. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 15.INITIALIZE POWER WINDOW CONTROL SYSTEM