The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the power window regulator motor removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
67491A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
74232
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)
74231
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
67655
6.REMOVE FRONT DOOR TRIM GARNISH
67601
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
68171B
8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
67831
9.REMOVE FRONT DOOR SERVICE HOLE COVER
10.REMOVE HOLE PLUG
11.REMOVE WINDOW REGULATOR SHIM
68101
12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
13.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY
85710E
14.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
Remove the 3 bolts and power window regulator motor assembly.
| *a | Protective Tape |
| *b | Drum |
Using a screwdriver with its tip wrapped in protective tape, carefully remove the power window regulator motor assembly while holding down the drum.