Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for TMC Made M15A-FKS) › from 2020.09
RM36W0E _54 Brake _088656 BRAKE SYSTEM (OTHER) _0447365 VACUUM PUMP(for TMC Made M15A-FKS) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for TMC Made M15A-FKS)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 29300 1.INSTALL VACUUM PUMP ASSEMBLY

a.

When reusing the vacuum pump assembly:

i.
C435071

Install a new No. 1 vacuum pump O-ring to the vacuum pump assembly.



b.
C435072C01
1.25,0.948 1.5,0.542 1.5,0.542 1.667,0.542 true 1.656,1.792 1.823,1.792 1.823,1.792 1.99,1.375 true 1.448,1.698 1.646,1.896 0.198,0.198 10 true *a 1.667,0.458 1.865,0.656 0.198,0.198 10 true *b
*a Coupling Teeth
*b Groove


Install the vacuum pump assembly so that the coupling teeth of the vacuum pump assembly and groove of the camshaft are engaged.

NOTICE:
·

Ensure that the vacuum pump assembly is installed securely.

·

Be careful not to pinch the No. 1 vacuum pump O-ring.




c.

Using an 8 mm socket wrench, install the vacuum pump assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

After installation, check that there are no gaps between the matching surfaces and that the vacuum pump assembly is not installed at an angle.



Hide 82121 2.INSTALL ENGINE WIRE

a.

Install the engine wire with the bolt and clamp.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the connector.


c.

Engage the 2 clamps to install the engine wire.


d.

Connect the 6 connectors.


e.

Engage the clamp to install the engine wire.


f.

Install the engine wire with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


g.

Connect the 2 connectors.


h.

Engage the clamp to install the engine wire.


i.

Install the engine wire with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


j.

Connect the 2 connectors.


Hide 77261D 3.INSTALL FUEL TANK TO CANISTER TUBE

a.

Install the fuel tank to canister tube.


Hide 44777 4.CONNECT NO. 1 VACUUM HOSE CONNECTOR

a.

Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.

NOTICE:
·

Check that there is no foreign matter on the connecting parts.

·

After connecting the No. 1 vacuum hose connector, check that the vacuum pump assembly and No. 1 vacuum hose connector are securely connected by pulling on them.