Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB (for TMC Made G16E-GTS) › from 2020.09
RM36W0E _52 Drivetrain _087260 AXLE AND DIFFERENTIAL _0447528 REAR AXLE HUB(for TMC Made G16E-GTS) G

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for TMC Made G16E-GTS)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42491 3.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 5.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C443055

Using a dial indicator, check for looseness near the center of the rear axle hub.

Maximum Looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



HINT:

If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.



Hide 6.INSPECT REAR AXLE HUB RUNOUT

a.
C443060

Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.

Maximum Runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolts.

·

Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.



HINT:

If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.



Hide 8.ADJUST PARKING BRAKE SHOE CLEARANCE

Hide 42491 9.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 11.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL

Hide 12.INSTALL REAR WHEEL