Home › Engine / Hybrid System › G16E-GTS (ENGINE MECHANICAL) › CYLINDER HEAD GASKET › from 2020.09
RM36W0E _51 Engine / Hybrid System _095252 G16E-GTS ENGINE MECHANICAL _0447810 CYLINDER HEAD GASKET A

G16E-GTS ENGINE MECHANICAL  CYLINDER HEAD GASKET  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cylinder head gasket removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Cylinder head sub-assembly


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 13501A 1.REMOVE INTAKE CAMSHAFT SUB-ASSEMBLY

Hide 13801 3.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

Hide 13750 4.REMOVE VALVE LASH ADJUSTER ASSEMBLY

Hide 11101 6.REMOVE CYLINDER HEAD SUB-ASSEMBLY

Hide 11115 7.REMOVE CYLINDER HEAD GASKET

a.
A479669

Remove the cylinder head gasket from the cylinder haed sub-aseembly/


Hide 11101A 8.INSPECT CYLINDER HEAD SET BOLT