Home › Suspension › REAR SUSPENSION › REAR TRAILING ARM › from 2020.09
RM36W0E _53 Suspension _087264 REAR SUSPENSION _0447926 REAR TRAILING ARM A

REAR SUSPENSION  REAR TRAILING ARM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear trailing arm assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment Calibration
·

DTCs are stored

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 890C0A 2.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.
C445840

Remove the nut to separate the No. 3 parking brake cable assembly from the rear trailing arm assembly.


Hide 3.SEPARATE REAR SPEED SENSOR

a.
C445841

Disengage the 3 clamps.


b.

Remove the bolt and separate the rear speed sensor from the rear trailing arm assembly.


Hide 48840A 4.REMOVE REAR STABILIZER LINK ASSEMBLY

Hide 48780E 5.REMOVE REAR TRAILING ARM ASSEMBLY

a.
C445842C01
0.875,1.458 1.208,1.458 true 2.135,1.688 2.406,1.688 true 0.656,1.323 0.969,1.521 0.313,0.198 10 false *a 2.458,1.552 2.771,1.75 0.313,0.198 10 false *b
*a Wooden Block
*b Transmission Jack


Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.

NOTICE:
·

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

·

Make sure to perform this operation with the vehicle kept as low as possible.




b.
C445843

Remove the 2 bolts to separate the rear trailing arm assembly from the rear axle carrier sub-assembly.


c.
C445859

Remove the 4 bolts and rear trailing arm assembly.


Hide 48753C 6.REMOVE REAR NO. 1 SUSPENSION SUPPORT COVER

a.
C445844

Secure the rear trailing arm assembly in a vise using aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Disengage the 3 claws to remove the rear No. 1 suspension support cover.


Hide 48727 7.REMOVE REAR SUSPENSION ARM BRACKET

a.
C445845

Remove the bolt, nut and rear suspension arm bracket from the rear trailing arm assembly.

NOTICE:

Loosen the nut with the bolt secured.