Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.APPLY HIGH TEMPERATURE GREASE
|
High Temperature Grease |
Apply high temperature grease to the areas of the parking brake plate which make contact with the shoes as shown in the illustration.
47612
2.INSTALL PARKING BRAKE SHOE LEVER
Using needle-nose pliers, install the parking brake shoe lever to the parking brake cable assembly.
|
High Temperature Grease |
Apply high temperature grease to the areas of the parking brake shoe lever which make contact with the No. 2 parking brake shoe assembly.
46590
3.INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY
Insert the pin of the parking brake shoe lever into the No. 2 parking brake shoe assembly.
Using SST, install the No. 2 parking brake shoe assembly with the parking brake shoe hold down spring and parking brake shoe hold down spring pin.
46580
4.INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY
Using SST, install the No. 1 parking brake shoe assembly with the parking brake shoe hold down spring and parking brake shoe hold down spring pin.
47406A
5.INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET
|
High Temperature Grease |
Apply high temperature grease to the parking brake shoe adjusting screw set as shown in the illustration.
Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand.
Install the parking brake shoe adjusting screw set.
46550A
6.INSTALL NO. 1 PARKING BRAKE SHOE RETURN TENSION SPRING
Using SST, install the No. 1 parking brake shoe return tension spring.
47614
7.INSTALL PARKING BRAKE SHOE STRUT
Pull the No. 1 parking brake shoe assembly towards the front of the vehicle by hand.
Install the parking brake shoe strut.
46550E
8.INSTALL NO. 2 PARKING BRAKE SHOE RETURN TENSION SPRING
|
High Temperature Grease |
Apply high temperature grease to the areas of the No. 2 parking brake shoe return tension spring which make contact with the No. 2 parking brake shoe assembly and parking brake shoe strut.
Using SST, install the No. 2 parking brake shoe return tension spring.
Insert the tip of the No. 2 parking brake shoe return tension spring into the hole in the parking brake shoe strut as shown in the illustration.
46550G
9.INSTALL NO. 3 PARKING BRAKE SHOE RETURN TENSION SPRING
Using needle-nose pliers, install the No. 3 parking brake shoe return tension spring.
10.CHECK PARKING BRAKE INSTALLATION
Check that each part is installed properly.
| *A | LH Side | *B | RH Side |
|
Front of the Vehicle | - | - |
There should be no oil or grease on the friction surfaces of the shoe linings or discs.
42432
11.INSTALL REAR DISC
12.ADJUST PARKING BRAKE SHOE CLEARANCE
42491
13.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
14.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
15.ADJUST PARKING BRAKE LEVER TRAVEL
16.INSTALL REAR WHEEL