Home › Engine / Hybrid System › G16E-GTS (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2020.09
RM36W0E _51 Engine / Hybrid System _095691 G16E-GTS EMISSION CONTROL _0449385 DIFFERENTIAL PRESSURE SENSOR A

G16E-GTS EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89481B 1.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Install the differential pressure sensor to the sensor bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

HINT:

Make sure there is no oil on the bracket.



b.

Connect the vacuum transmitting hose assembly to the differential pressure sensor and slide the clip to secure it.

HINT:

Install the vacuum transmitting hose assembly and hose clamps as shown in the illustration.



c.

Connect the differential pressure sensor connector.


Hide 89481B 2.LEARNING DIFFERENTIAL PRESSURE SENSOR

a.

Start the engine and allow it to idle until the engine coolant temperature reaches 75°C (167°F) or higher (A).


b.

Turn the engine switch off and wait for 30 seconds or more (B).


c.

Repeat the above procedures (A) and (B) 3 times.

HINT:

Procedures (A) and (B) must be repeated 3 times to complete the differential pressure sensor learning process.



Hide 55701J 3.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 55701J 4.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

Hide 55734A 5.INSTALL WATER GUARD PLATE RH (for LHD)

Hide 55735A 6.INSTALL WATER GUARD PLATE LH (for RHD)

Hide 55815E 7.INSTALL FRONT NO. 1 VENTILATOR SEAL (for LHD)

Hide 55815E 8.INSTALL FRONT NO. 1 VENTILATOR SEAL (for RHD)

Hide 9.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY