The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the air conditioning amplifier assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for 1KR-FE:
Click hereGeneral>MAINTENANCE>1KR-FE AUXILIARY BATTERY>REMOVAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
55606
3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
78110K
4.REMOVE ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY (for LHD)
for 1KR-FE:
Click hereEngine / Hybrid System>1KR-FE (ENGINE CONTROL)>ACCELERATOR PEDAL>REMOVAL
for M15A-FKS:
Click hereEngine / Hybrid System>M15A-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>REMOVAL
for M15A-FXE:
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>ACCELERATOR PEDAL SENSOR>REMOVAL
88650N
5.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
Remove the screw.
Disengage the guides to separate the air conditioning amplifier assembly as shown in the illustration.
for Automatic Air Conditioning System:
Disconnect 3 connectors to remove the air conditioning amplifier assembly.
for Manual Air Conditioning System:
Disconnect connector to remove the air conditioning amplifier assembly.