Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER (for G16E-GTS) › from 2020.09
RM36W0E _58 Vehicle Interior _088019 HEATING / AIR CONDITIONING _0449583 AIR CONDITIONING AMPLIFIER(for G16E-GTS) A

HEATING / AIR CONDITIONING  AIR CONDITIONING AMPLIFIER(for G16E-GTS)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the air conditioning amplifier assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Air conditioning amplifier assembly Initialize servo motor (Air Conditioning System) DTCs are stored (Click here)
w/ Stop and Start System:
1.

Reset air conditioning information

2.

Learning of air conditioning information


Engine start function (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 88650N 4.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

a.

Remove the 2 clips to separate the front floor carpet assembly as shown in the illustration.

I116938


b.
I117122

Remove the 2 screws.


c.

Disengage the guide to remove the air conditioning amplifier assembly.


d.

Disconnect the 3 connectors.