The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.
Click hereEngine / Hybrid System>G16E-GTS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
17751
3.REMOVE NO. 1 AIR CLEANER INLET
17881
4.SEPARATE NO. 1 AIR CLEANER HOSE
5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
89661
6.REMOVE ECM
Disengage the clamps.
Raise the 3 lock levers while pushing the locks on the levers, and disconnect the 3 ECM connectors.
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the bolt, nut and ECM.
If the ECM has been struck or dropped, replace it.
89667E
7.REMOVE NO. 1 ECM BRACKET
Remove the screw and No. 1 ECM bracket from the ECM.
89668
8.REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket from the ECM.