Home › Engine / Hybrid System › G16E-GTS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 2) › from 2020.09
RM36W0E _51 Engine / Hybrid System _095127 G16E-GTS ENGINE CONTROL _0449866 AIR FUEL RATIO SENSOR(for Sensor 2) A

G16E-GTS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89467C 1.INSTALL NO. 2 AIR FUEL RATIO SENSOR

a.
A480380C01
2.01,1.281 2.292,0.885 true 2.969,2.302 3.125,2.5 0.156,0.198 10 true *a 2.292,0.771 2.927,0.979 0.635,0.208 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the No. 2 air fuel ratio sensor to the front exhaust pipe assembly.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the No. 2 air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.
A480406

Engage the 3 wire harness clamps.

NOTICE:

Make sure the white tube is between the wires.



c.

Connect the No. 2 air fuel ratio sensor connector.


Hide 57543C 2.INSTALL CENTER NO. 1 FLOOR BRACE

Hide 57533B 3.INSTALL CENTER FRONT FLOOR BRACE

Hide 51447D 4.INSTALL CENTER NO. 4 ENGINE UNDER COVER

Hide 6.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the No. 2 air fuel ratio sensor.

Click hereEngine / Hybrid System>G16E-GTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION