17111
1.REMOVE INTAKE MANIFOLD
51410
2.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
16278
3.REMOVE NO. 2 WATER BY-PASS PIPE
Remove the bolt and nut.
Disengage the clamp and remove the No. 2 water by-pass pipe.
89448D
4.REMOVE OIL PRESSURE AND TEMPERATURE SENSOR
Disconnect the oil pressure and temperature sensor connector.
Using a 24 mm deep socket wrench, remove the oil pressure and temperature sensor.
If the oil pressure and temperature sensor is dropped or subjected to a strong impact, replace it with a new one.