Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › ACTIVE TORQUE SPLIT AWD SYSTEM › from 2020.09
RM36W0E _52 Drivetrain _095692 GF1A TRANSFER / 4WD / AWD _0449992 ACTIVE TORQUE SPLIT AWD SYSTEM D

GF1A TRANSFER / 4WD / AWD  ACTIVE TORQUE SPLIT AWD SYSTEM  VEHICLE CONTROL HISTORY  


NOTICE:

When checking the vehicle control history, first record the output codes and after clearing the history, check the output history again.


CHECK VEHICLE CONTROL HISTORY (ACTIVE TORQUE SPLIT AWD SYSTEM)


a.

According to the display on the GTS, check the vehicle control history.

Chassis > Four Wheel Drive > Utility
Tester Display
Vehicle Control History (RoB)
50005 448 1055
Vehicle Control History Item (Active Torque Split AWD System)
Code Tester Display Measurement Item 4WD / AWD Warning message Handling
X2001 Steering Angle Sensor Malfunction Stores a history of receiving a sensor malfunction signal from the steering sensor with the IG1 terminal voltage 9.5 V or higher Not displayed Refer to How to Proceed with Troubleshooting in Electronically Controlled Brake System.
(Click here)
X2004 Speed Sensor Malfunction Stores a history of receiving a speed sensor malfunction signal from the skid control ECU (brake actuator assembly) Not displayed Refer to How to Proceed with Troubleshooting in Electronically Controlled Brake System.
(Click here)
X204A Acceleration Sensor Malfunction Stores a history of receiving a acceleration sensor malfunction signal from the skid control ECU (brake actuator assembly) Not displayed Refer to How to Proceed with Troubleshooting in Electronically Controlled Brake System.
(Click here)
X2087 Engine Malfunction Stores a history that an engine malfunction signal is generated continuously for 5 seconds or more Not displayed Refer to How to Proceed with Troubleshooting in SFI System.
(Click here)
X2103 Four-Wheel Drive Control System Temperature High Stores a history that the calorific value of the transmission coupling assembly exceeds the specified value, or of the estimated oil temperature of the transfer assembly exceeds the specified value Displayed
1.

Without turning off the engine, stop the high-load.

2.

Stop the vehicle.

3.

Turn the ignition switch off.

4.

Turn the ignition switch ON and check that "AWD System Malfunction 2WD Mode Engaged Visit Your Dealer" is not displayed on the multi-information display.

5.

Using the GTS, perform a Health Check.

6.

Refer to the flow chart(s) for the output DTCs.


X2104 Different Diameter Tire Stores a history that the vehicle is driven with tires of a load radius difference of 4% or higher between the front and rear tires Displayed Tire replacement
X263D 4WD/AWD Range Actuator Adjusted Value Not Written Stores a history that the compensation value has not been written Not displayed Write the compensation value
(Click here)



CLEAR VEHICLE CONTROL HISTORY (ACTIVE TORQUE SPLIT AWD SYSTEM)


NOTICE:

When the vehicle control history is cleared, all the stored history items are cleared.


a.

According to the display on the GTS, clear the vehicle control history.

Chassis > Four Wheel Drive > Utility
Tester Display
Vehicle Control History (RoB)
50005 448 1055