Home › Drivetrain › CLUTCH › CLUTCH PEDAL SWITCH › from 2020.09
RM36W0E _52 Drivetrain _089426 CLUTCH _0424694 CLUTCH PEDAL SWITCH A

CLUTCH  CLUTCH PEDAL SWITCH  INSTALLATION  


PROCEDURE

Hide 88280A 1.INSTALL CLUTCH SWITCH ASSEMBLY (except G16E-GTS)

a.

for LHD:

i.
C446407C01
1.573,3.052 1.823,3.26 0.25,0.208 10 true *a
*a Clearance


Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.

Torque:
17.15 N*m (175 kgf*cm, 13 ft.*lbf)


ii.

Connect the clutch switch assembly connector.


iii.

Without depressing the clutch pedal, check that the clearance shown in the illustration is as specified.

Standard clearance:

3.2 to 3.6 mm (0.126 to 0.142 in.)




b.
C446408C01
1.708,3.021 1.906,3.25 0.198,0.229 10 true *a
*a Clearance


for RHD:

i.

Install the clutch switch assembly to the clutch pedal support sub-assembly with the nut.

Torque:
15.7 N*m (160 kgf*cm, 12 ft.*lbf)


ii.

Connect the clutch switch assembly connector.


iii.

Without depressing the clutch pedal, check that the clearance shown in the illustration is as specified.

Standard clearance:

1.8 to 2.8 mm (0.071 to 0.110 in.)




Hide 2.INSTALL CLUTCH PEDAL SUPPORT ASSEMBLY (except G16E-GTS)

Hide 31453A 3.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN (except G16E-GTS)

Hide 4.INSTALL STEERING COLUMN ASSEMBLY (except G16E-GTS)

Hide 84520 5.INSTALL CLUTCH START SWITCH ASSEMBLY

a.
C437884C03
1.448,0.615 1.635,1.031 true 1.25,3.125 1.688,3.552 true 1.198,0.49 1.448,0.677 0.25,0.188 10 true *a 0.99,3.042 1.24,3.229 0.25,0.188 10 true *a 0.063,0.083 0.333,0.292 0.271,0.208 12 true *A 0.073,2.521 0.344,2.729 0.271,0.208 12 true *B
*A for LHD
*B for RHD
*a Protrusion


Install the clutch start switch assembly to the clutch pedal support sub-assembly with the nut.

Torque:
for LHD : 15.68 N*m (160 kgf*cm, 12 ft.*lbf)
for RHD : 15.7 N*m (160 kgf*cm, 12 ft.*lbf)

NOTICE:
·

Insert the protrusion of the clutch start switch assembly into the hole in the clutch pedal support sub-assembly.

·

To prevent damage to the clutch start switch assembly, make sure not to rotate it during installation.




b.

Connect the clutch start switch assembly connector.


Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 7.INSPECT CLUTCH START SYSTEM